-
JRready KIT5129 GO/NO-GO Gage Kit 
JRready KIT5129 GO/NO-GO Gage Kit 
JRready KIT5129 GO/NO-GO Gage Kit 
JRready KIT5129 GO/NO-GO Gage Kit 
JRready KIT5129 GO/NO-GO Gage Kit 
JRready KIT5129 GO/NO-GO Gage Kit 
JRready KIT5129 GO/NO-GO Gage Kit 
JRready KIT5129 GO/NO-GO Gage Kit 
JRready KIT5129 GO/NO-GO Gage Kit -
-
JRready KIT5129 GO/NO-GO Gage Kit
1. The tool kit includes eight gages, used for testing indenter diameter of YJQ-W3Q, YJQ-M309;
2. Each gage has two ends: Green end: GO, red end: NO-GO;
3. Validity detection: Operate the tool to the fully closed position. The"GO"gage end (Green) can pass freely, but the NO-GO end (Red) can not pass completely.
Brand: JRready | Model: KIT5129 GO/NO-GO Gage Kit | Material: GCr15 |
Match Tool: YJQ-W3Q & YJQ-M309 | Internal Number: KIT5129 | Weight (g): 130 |
| The tool kit includes eight gages, used for the detection of indenter working diameters of PRECISETOOL YJQ-W3Q, YJQ-M309 crimp tool; The validity detection of indenters: operate the tool to the fully closed position. If the selector is right, the “GO” gage end (Green) can pass freely, but the NO-GO end (Red) can not pass completely. If the red end can also pass, the selectors of this crimping tool needs to be recalibrated. | ||
Gage insert diagram
| 1. Operate the tool to the fully closed working position. Set the crimp tool to the correct selector number 2. If the “GO” gage end (Green) can pass freely, but the NO-GO end (Red) can not pass completely, it means the tool is still qualified 3. If the “GO” gage end (Green) can not pass, but the NO-GO end (Red) can pass completely, it means the tool is not qualified |
Maintenance
1. After using, the gage should be put into the special tool box to prevent the bending deformation of the gage pin.
2. Regularly wipe with antirust oil to ensure that the surface of gage pin is clean.
197
